1. Open the front doors.
  2. Pull down the levers C1 and C2, and then pull the drawer out completely until it stops.
  3. Pull up and open the cover B6 [A].
  4. While holding B6 open, clean the rollers, sensors and guide plates.
  5. Close the cover B6.
  6. Clean the rollers and sensors.
  7. Pull down and open the cover B3.
  8. Clean the rollers while turning the knob B1. Clean the sensors and guide plates also.
  9. Close the cover B3.
  10. Remove the 2 screws, and then remove the cover.
  11. Remove the 2 screws, and then remove the dust catcher.
  12. Clean the dust catcher.
  13. Clean the roller while turning the knob B5. Clean the sensor, guide plate, and roller in the paper transfer unit also.
  14. Attach the dust catcher, and then secure it with the 2 screws.
  15. Attach the cover, aligning the notch on the cover with the claw, and then secure it with the 2 screws.
  16. Pull down the levers Z2 and Z3.
  17. Clean the left-hand side rollers while turning the knob Z1. Clean the left-hand side sensors and guide plates also.
  18. Clean the right-hand side rollers, sensors, and guide plates.
  19. Pull up the levers Z2 and Z3.
  20. Clean the sensor and guide plate on the entrance of the fusing unit.
  21. Pull up and open the cover D2.
  22. Clean the sensor and guide plate.
  23. Close the cover D2.
  24. Raise cover D3 [A] until [B] locks and the cover remains open.
  25. Clean the rollers while turning the knob D1. Clean the sensors and guide plates as well.
  26. Close the cover D3.
  27. Pull down and open the cover D4.
  28. Clean the rollers, sensor, and guide plates.
  29. Clean the antistatic brushes.
  30. Close the cover D4.
  31. Push the drawer back into the machine.
  32. Pull up the levers C1 and C2.
  33. Close the front covers.