• Make sure that the main power switch and AC power switch of the main machine are turned OFF and that its power cord is disconnected before doing the following procedure.

  1. Remove the screws from the banner sheet tray [A] and then separate the base tray [B] and cover [C] (x4).
  2. Insert the base tray [A] under the bypass tray.
  3. Hang the two joint plates [A] (provided with this option) in the gap under the extension tray.
  4. Move each joint plate [A] under the base tray edges and then fix them to the base tray (x1 each: M4x6).
    Fixing screws are provided with this option.
  5. Insert the cover [A] separated in step 1 between the extension tray and base tray, and then fix it (x4: M4x6).
    Fixing screws are provided with this option.
  6. Pull the extension tray [A] and then hang it on the screws as shown below.
  7. Stand the end fences [A] (provided with this option) as shown below.
    The end fences are held to the banner sheet tray by magnets.