There are two ITB jigs:

  • The cleaning belt jig [A] (the large jig).
  • The ITB drive roller jig [B] (the small jig).

These jigs are stored inside the machine. They are required for servicing the ITB belt.

  1. Open the front doors.
  2. Lower the ITB lever, and then unfasten the ITB cover. (x4).
  3. Remove the ITB cover.
  4. Lay the cover on a flat clean surface.
  5. The large jig is attached at [A] and the small jig at [B].
  6. Peel the covers off the tapes on the back of the jigs.
  7. Attach the large jig [A] in the compartment on the left, and the small jig [B] in the compartment on the right.
  8. When a jig is required for servicing the ITB unit, just pull it away from its Velcro fastener.
  9. After you re-attach the cover [A], be sure to raise the ITB lever [B]. The right front door will not close if this lever remains down.