• Make sure that the main machine is switched off and that its power cord is disconnected before doing the following procedure.

Shipping Materials

  1. Remove the motor protector plate [A] ( x4).

Rear Cover

  1. Remove the upper rear cover [A] (x4).

Right Upper Panel

  1. Remove the right upper panel [A] (x4).

Punch Registration Unit

  1. Use a pair of nippers to remove the knockouts [A].
  2. Raise and open lever "RB3" [B].
  3. Remove the plate [A] and discard it ( x4).
  4. Insert the harness connectors [A] through the hole [B].
  5. Make sure the harness connectors are through the hole completely and visible at the rear of the machine.
  6. Set and fasten the punch registration unit [C] ( x4, 2 screws each at front and back).
  7. Clamp the harness [A] ( x4).
  8. Clamp the harness [B] ( x2).

Sensor Arm

  1. Attach the sensor arm [A] (x1, x1).
  2. Make sure the sensor arm swings freely on the step screw and spring.
  3. Attach the harness [B] to the sensor on top of the arm.

Punch Drive Unit, Punch Unit

  1. On the punch unit, connect the harness [A] (x1, x1).
  2. Attach the punch mechanism [A] to the rails of the punch unit ( x1).
    • If you are installing the punch unit for Europe [1], connect the harness [B] ( x1, x2).
    • The punch unit for North America [2] has no punch switching motor, so this harness is not required.
  3. At the front, insert the punch unit [A] into the finisher and fasten it ( x4).
  4. Remove the shoulder screw with the red tag [B], and detach the tag and wire.

  5. After removing the screw from hole , re-attach it at hole .

    • This screw must remain attached to the punch unit.
    • Before removing the punch unit from the finisher, the screw must be removed from hole and re-attached at hole . This stabilizes the punch unit and prevents it from wobbling from side to side while it is being removed and handled after removal.

  6. At the front, slide the punch-out hopper [A] into the finisher.
  7. Route the harnesses from the CIS unit [A] through the hole.
  8. Connect the harnesses at and ( x2).
  9. If you are installing the punch unit for Scandinavia, fasten the extra connector at ( x1).
  10. Finish clamping the harnesses as shown above.

Punch Control Board

  1. Install the punch control board (x4).
  2. Connect the punch relay harness to the punch control board and the punch main control board .

Final Connection

  1. Connect the connectors to the punch unit PCB [A] ( x2).
  2. Release the harness [A] from the frame ( x2).
  3. Connect the harness [A] to the punch control board ( x1).
  4. Gather the harness [A] and the board relay harness [B] and clamp them ( x3).

  5. Push the caster up until it stops and is not touching the floor.
  6. Tighten the caster cover screws.
    • This prevents the caster from snagging on a carpet or door jamb when the finisher is pushed along the floor.
    • After the finisher has been moved to its new location, lower the caster again and tighten the screws.