- Plug in the power cord, and then turn the machine on.
- Enter the SP mode.
Do SP2108-001 to download the operation parameters for the laser unit.
- Do not open the doors or switch the machine off while the machine is downloading the parameters.
- If the machines returns an SC code or displays “Failure”, cycle the machine off/on then execute SP2108-001 again.
- Test for skew and magnification problems, and then correct them if necessary. (See the “Troubleshooting” section.)
- Do SP2170-001 and select the number to print the Trimming Pattern.
- Check the borders on the sheet and check if the pattern is perfectly square.
- If the pattern is down on the right edge [A], the laser unit should be rotated counter-clockwise one notch.
-or-
If the pattern is up on the right edge [B], the laser unit should be rotated clockwise one notch. - Disassemble the machine again as far as the start of laser unit removal.
- Loosen the screws of the laser unit, and then rotate it the number of notches necessary for the adjustment.