1. The long screws round-head [1] were removed from the right side of the left tandem tray, and the short round-head screws [2] were removed from the left side of the left tandem tray.
  2. Select one of the long screws to fasten the pin bracket [A].
  3. Set the pin bracket [A] in the center of the middle rail.
  4. Fasten the bracket to the middle rail [B] (x1).
  5. You need four TCRU screws to attach the tray unit:
    • [1] The screws you removed from the right side of the right tandem unit
    • [2] Two accessory screws provided. (These four screws are the same size.)
  6. Using the installed pin bracket [A] as an aiming point for the hole in the bottom of the tray unit [B], lower the tray unit onto the rails.
  7. Make sure that the head of the pin is through the hole in the bottom of the tray.
  8. Loosely attach the left side of the tray unit to the left rail [A] (x2). Do not tighten these screws yet.
  9. Side the rail [A] to the front or back to align the screw holes.
  10. Loosely attach the right side of the tray unit at the front [B] and center [C] (x2). Do not tighten these screws yet!
  11. Check the left rail.

    • Make sure that you can see the holes of the rail aligned at holes [A] and [B] of the tray unit.
    • There are no screws here, but the alignment of these holes at [A] and [B] tells you that the tray is positioned correctly.
    • If the holes are out of alignment, loosen or remove some of the screws, and then adjust the position of the rails until the holes appear aligned.

    • If the four screws are tightened with these holes not aligned correctly, you may not be able to open the paper tray after it has been pushed into the machine.

  12. After confirming that the holes are aligned correctly, tighten the screws on the left and right sides of the tray unit (x4).