Uneven Density within 90 mm (3.5 in.) of the Trailing Edge

Printing in the area extending approximately 90 mm (3.5 inches) from the trailing edge is fainter or denser.

Cause:

This may occur when:

• Printing is done at low temperature or humidity
• Printing a single-dot halftone image

Solution:

The solution depends on whether the area within 90 mm (3.5 inches) of the trailing edge is denser or fainter. However, if the paper is not registered with the Advanced User Settings, the timing roller speed must be adjusted for the paper type and paper thickness for the paper in use. (SP 1-006-001 Fine Adj Trans Tmg Roll Spd Plain:Weight (number) 001 to 100)

If the area within 90 mm (3.5 inches) of the trailing edge is fainter

1. In Advanced Settings for the custom paper in use, check the present value in Transfer Timing Roller Feed Speed Adj. (SP1-963-001 to 100: Trans Timing Roll Spd:Fine Adj Custom Paper 001 to 100) Is it higher than +1.0%?
   

   Yes	Consult the product specialist.
   No	Go to the next step.

2. Increase the value in Transfer Timing Roller Feed Speed Adj by 0.1 percentage point.
3. Print the image. Is the problem resolved?
   

   Yes	Finished!
   No	Repeat Steps 2 and 3. If the problem persists even though you have increased the value to +1.0%, consult the product specialist.

If the area within 90 mm (3.5 inches) of the trailing edge is denser

1. In Advanced Settings for the custom paper in use, check the present value in Transfer Timing Roller Feed Speed Adj. (SP 1-963-001 to 100: Trans Timing Roll Spd:Fine Adj Custom Paper 001 to 100) Is it lower than -1.0%?
   

   Yes	Consult the product specialist.
   No	Go to the next step.

2. Decrease the value in Transfer Timing Roller Feed Speed Adj by 0.1 percentage point.
3. Print the image. Is the problem resolved?
   

   Yes	Finished!
   No	Repeat Steps 2 and 3. If the problem persists even though you have decreased the value to -1.0%, consult the product specialist.