For best results with this adjustment, use a sheet of T6000 (70W) paper. If this type of paper is not available, you can also use:

  • Hammermill Fore MP White (20 lb) LT
  • Normal copy paper (80 g/m2) A4
  1. Remove the CIS element (see the previous section).

Inserting the Paper: Procedure 1

  1. From downstream (the transfer timing roller side), insert one clean sheet of white A4 paper into the registration unit as far where the CIS element has been removed [A].

    • If you experience difficulty inserting the paper, do the procedure below.

Inserting the Paper: Procedure 2

  1. Cut out a section of the paper using the dimensions shown.
  2. While standing to the right of the registration unit, rotate the rotary gate roller counter-clockwise with your fingers until you can see the cams (this releases pressure on the roller so that the paper can be inserted).
  3. Raise the plastic cover, insert the prepared sheet [A] from upstream as shown, and then push it as far as where the CIS element was removed.
  4. Insert another sheet of paper into the entrance of the fusing unit to prevent a paper jam (JAM 1) after you turn the machine on.

Light Adjustment

  1. Install the new CIS element.

    • If the machine issues a JAM001 alert, ignore it and continue with this procedure.

  2. Enter the SP mode, and then execute SP1912-001.
  3. After the SP executes, remove the inserted paper.
  4. Re-attach the bracket. This completes the procedure.