1. Feed cover (Feed Cover)

  2. Disconnect the lower guide, in order from rear to front: Blue, , Black step screws (x1,x2).

    • These screws must be re-installed in the same order: the blue screw at the back and the black screws at the center and front.

  3. Remove the guide.

    Double-feed Sensor 1 (Option)

    Interval Sensor

    Original Width Sensors


    Double-feed Sensor 1 (Emitter)

    • This machine is not equipped with double-feed sensors before shipping. This feature is an option for this machine. The double-feed sensor kit must be purchased and installed. This sensor will not be present unless the kit has been installed.

  4. Disconnect the sensor board (x1, x2).
  5. Remove the sensor board.

    Interval Sensor
  1. Disconnect the sensor bracket (x1).
  2. Disconnect the sensor (x1, x4).

    Original Width Sensors
  1. Disconnect the sensor bracket (x2).
  2. Disconnect the sensor bracket:
    [A] Rear (x1, x1)
    [B] Front (x1, x1)
  3. Open and disconnect the remaining clamps and sensors (x4, x3).
  4. Remove the bracket.