1. Remove the inserter rear cover [A] (x2).
  2. Remove the top cover angle adjustment shaft [A] (x1).
  3. Open the top cover [A].
  4. Remove the front cover [B] (x2).
  5. On the right side of the adjustment mechanism, loosen:
    [A] Screw
    [B] Hex nut
    • With a hex wrench, turn the adjustment screw [C] to adjust the gap by raising or lower the inserter.
    • Turning clockwise raises the inserter.
    • Turning counter-clockwise lowers the inserter
  6. On the left side of the adjustment mechanism, adjust the height of the inserter on the left. (The procedure is the same as Step 5.)
  7. Reattach:
    • Inserter front cover (x2)
    • Top cover angle adjustment shaft (x1)