1. At the left rear corner of the host machine, confirm that cover [A] has been reattached (x6).
  2. On the right side of the host machine, attach:
    [A] Left joint bracket ("L") ( x2)
    [B] Right joint bracket ("R") ( x2)
  3. Open the front door of the relay unit.
  4. Remove the screw [A].
  5. Pull the lock bar [B] out to lower it.
  6. Slowly push the bookbinder against the side of the host machine.
  7. Push in the lock bar [A] to raise it and lock it in the cutouts of the joint brackets attached to the host machine.
  8. Reattach the screw [B] to fasten the lock bar in the raised position.
  9. Remove the brace [A] from the right front door of the bookbinder. (x1)
  10. Remove the wrench [B].
  11. Place the shoes [A] and [B] under the stoppers at each corner of the bookbinder.
  12. Use your fingers (or the wrench) to turn the nut in the direction of the arrow until the nut stops on top of the shoe.
  13. At each corner, use the wrench [A] to turn the nut in the direction of the arrow to raise the bookbinder [B] until the caster [C] raises off the floor.
  14. Place a level on the top at the front and right edges of the machine to confirm that the bookbinder is level.
  15. Adjust the corner stoppers until the machine is level.
  16. Connect the bookbinder interface cable to the host machine.