Depending on the cause of the problem, do one of the following:

The side fences in the paper tray are too far apart.
  • If the side fences are too far apart, the paper may be skewed.
  • Adjust the side fences to match the paper width.
  • When you close the paper tray, the side fences may become misaligned due to the weight of the paper. To prevent this, close the paper tray slowly.
A scrap of paper or some other small fragment is jammed in the paper feed path.

Remove the fragment. (Cleaning the Paper Feed Path)

The correct amount of paper buckle has not been specified.

Adjust the degree of paper arching at the registration gate.

If using paper of Paper Weight 1 to 4

  1. On the machine operation panel: Image Position group in the Adjustment Settings for Skilled Operators menu, change the value in Adjust Registration Paper Buckle. (SP1-004-1 to 3: Reg. Buckle Adjust: Tray 1 to 3).

If using paper of Paper Weight 5 to 7

  1. On the machine operation panel: Image Position group in the Adjustment Settings for Skilled Operators > Image Position > Adjust Registration Paper Buckle (Thick Paper) > Change the value. (SP1-005-001 to 3: Reg. Buckle Adj.: Thick 5 to Thick 7).
  2. Increase (+) or decrease (-) the value for the paper tray in use, and then print the image.
    • If the problem persists even though the setting has reached its maximum value, try decreasing the setting.
    • If the problem persists even though you have tried the complete range of settings from minimum to maximum, do the procedure below.