This procedure is not required if the positioning pin slides freely in and out of the hole when the inserter top cover is lowered and raised.

  1. Raise the inserter.
  2. Loosen (do not remove) the hinge screws [A] (x2: M4).
  3. Use a small wrench to loosen the adjustment screw [A] (Do not remove!).
  4. Insert a hex wrench (Allen key) [B] into the tip of the adjustment screw.
    • Rotating the screw clockwise moves the inserter to the right.
    • Rotating the screw counter-clockwise moves the inserter to the left.
  5. Tighten the hinge screws (x2: M4).
  6. Lower the inserter again to see if the positioning pin and hole fit snugly.
  7. Repeat this procedure until the pin and hole engage and disengage completely and smoothly.