1. Remove the top cover [A] of the controller box (Caps x2,x2).
  2. Remove the back cover of the controller box (x11).
  3. Locate the four holes [A] on the frame of the controller box.
  4. Attach the standoffs [B] (x4).
  5. Attach the connection board [A] to the standoffs.
  6. Free the harness [B] (x1).
  7. Connect the harness at [C] (x1).
  8. Be sure to close clamp [D] ( x1)
  9. Use a knife or a pair of nippers to remove the square knock-out from the controller box top cover.
  10. Pass the connector of the device harness through the hole where you removed the knock-out.
  11. Connect the counter device harness to the interface board.
  12. Set the device at a convenient location.
  13. If an LCT is installed on the right side of the machine, place the device on the LCT.