Follow this procedure to remove the controller box so that the machine can fit more easily through a door or onto a small elevator when it has to be moved.

  1. Open the controller box. (Opening the Controller Box)
  2. Remove the controller box rear cover. (Opening the Controller Box)
  3. Loosen the screws, slide the inner cover to the left, and then remove it.
  4. Free the harnesses (x8).
  5. Disconnect the harnesses at the upper left corner of the controller board (x2, x4)
  6. Disconnect harnesses from the bottom of the board (x3).
  7. At the lower left, disconnect the shielded cable (x1, x1, x1)
  8. Disconnect harnesses on the back side of the controller box (x4, x9).
  9. Disconnect the fan [A], and then remove the PSU cover [B] (1x, x1, x4).
  10. Disconnect the PSU-C (x8, x7)
  11. Disconnect the double harness (x2, x1)
  12. Pull the shielded cable through the frame.
  13. At the top, first pull the black cables [A] through the frame.
  14. Next, pull the double harness [B] through the frame.
  15. Finally, pass the ferrite core [A] of the shielded cable through the hole, and then pull the cable [B] through the hole.
  16. At the bottom of the box on the right rear corner of the machine, remove the lock bracket (x1).
  17. Grip both ends of the top of the box.
  18. Pull the box up off its hinge pegs, and then pull it away from the machine.
  19. Set the box in a location where it will not fall over while you move the machine.