• Before you begin this procedure, confirm that the machine is off.

  1. If the machine is on, press the operation power switch on the left front corner of the machine.
  2. Wait for the message to go off before you do the procedure below.
  3. Open the left front door and turn off the main power switch.
  4. Make sure the machine is off, and then open the left front door.
  5. Turn on the main power switch (ignore the door open alert).
  6. Remove the two toner bottles from the packing.
  7. Rotate each bottle at least 10 times to make sure that the toner inside is loose.
  8. Open the toner bank door, insert both toner bottles, and then close the toner bank door.
  9. Enter the SP mode
  10. Do SP7628-002 (Clear PM Counter).
  11. Exit the SP mode.
  12. Close the left front door.
  13. Toner filling will begin automatically after closing the left front door.
  14. As soon as toner filling completes, the machine will automatically start process control. (If there is a problem, go to the next section.)
  15. Process control executes.
  16. As soon as process control completes, a message on the operation panel tells you that copying can begin. (If there is a problem, go to the next section.)
  17. Enter the SP mode.
  18. Do SP3012-001 (ProCon OK?) to confirm that process control succeeded.
    • If process control executed normally, you should see "11" displayed.
    • If you see any other numbers displayed, go to the next section.
  19. Exit the SP mode.
  20. You are finished, and the machine is ready to use.