These are the instructions for installing the unit on the LCIT RT5070. If you are doing this installation for the LCIT RT5080, go to the next section.

  1. Remove the right edge cover (x2).
  2. Next, remove the top cover (x2).
  3. Install the joint pins.
  4. Turn the pins clockwise until they are snug against the frame.

  5. Attach the accessory support plate (x1).

    • The Multi Bypass Unit weighs about 20 kg. (44 lb.).

  6. Lift the bypass tray and set it on top of the joint pins. The pins should slide into holes in the bottom of the tray.
  7. On the right, secure the tray with one screw at the accessory support plate attached in Step 5 (x1).l
  8. Check the rear [A] and front [B].
  9. Make sure the tray is flat on top of the LCIT, and that the joint pins are visible.
  10. Fasten the tray at the front [A] and rear [B] (x2).
  11. At the rear, open the clamp to free the three harness cables.
  12. Open the clamp, and then remove the short harnesses. These harnesses are not used for this installation.
  13. Locate the three connection points inside the tray, and then connect the harnesses (x3).
    • [A] shows the connection points inside LCIT RT5080
    • [B] shows the connection points inside LCIT RT5070
    • [C] is not used for this installation
  14. When you close the harnesses, make sure that the two lock bands are positioned as shown above.
  15. Next, install the left cover (x2).
  16. Attach the rear cover (x2).
  17. If the tray is closed, open it.
  18. Attach the front cover (x1).
  19. This completes installation of the Multi Bypass Tray.
  20. Dock the LCIT to the side of the main machine.