The HDD unit contains two separate disks.

  • The HDD unit contains two disks that must always be replaced as a set.
  • Never remove an HDD unit from a machine, or remove an old HDD from the work site without permission of the customer.

  • Before replacing the HDD unit, if possible copy the address book data to an SD card with SP5846-051.

    • Information stored on the HDD (stamps, documents stored on HDD, etc.) will be lost after the HDD is replaced.
    • Lost data may need to be replaced manually after HDD replacement.

  1. Disconnect the HDD [A] (x2).
  2. Disconnect the right side of the bracket [B] (x2).
  3. Disconnect the bottom and the left side [A] (x2).
  4. Remove the bracket [B] (with HDDs attached).
  5. Disconnect the upper HDD (x2).
  6. Disconnectthe top and bottom sides [A] and [B] of the upper HDD (x4).
  7. Remove the upper HDD.
  8. Remove the lower HDD (x4).

Re-installation

  • There is a notation on the metal panel to remind you to re-connect the HDD cables correctly: Red over Black.
  • Reconnecting these cables incorrectly will cause an error. If this occurs, just switch the machine off and connect them correctly. (The HDD will not be damaged.)