1. Open the controller box (Opening the Controller Box)
  2. Lower the IOB (x8, x3, x4). (Lower the IOB)
  3. Remove the registration entrance motor bracket (Registration Entrance Motor)
  4. Remove the harness cage (x3, x2).
  5. Remove the shield [A] (x1).
  6. Disconnect the harness (x2).
  7. Disconnect the bracket of the motor [A] (x3, x1)
  8. Separate motor [A] and bracket (x2).

    Re-installation
  1. When re-assembling motor [A] and bracket [B], first loosen the three screws to release the tension on the spring [C].
  2. Set the belt [D] and the motor gear [E], and then fasten the motor and bracket together (x2).
  3. Tighten the three screws to restore tension on the belt.
  4. Before you re-attach the motor, make sure that the flat sides [A] and [B] of both shafts are up and level with one another.

  • You can turn either gear so the flat side is facing up. Make sure both flat sides are facing up after setting the motor.
  • If these flat sides are not facing up and parallel, the gears will be out of alignment. This can cause paper jams in the registration unit.