1. Remove all the tape and shipping materials from the tray unit [A].
  2. Remove the cover [B].
  3. Remove all tape and shipping materials from the transport unit [C].
  4. Remove the tape and covers from both connectors [D].
  5. Attach the accessory bracket [A] to the downstream unit (x4 M6x8).

  6. Peel the tape off the cushion [A] and attach it.

    • Two yellow cushions are provided as accessories with the main machine. Use these cushions only if the cover interposer tray will be connected directly to the main machine.
    • The gray cushion provided with the cover interposer tray should be attached to the cover interposer tray.

  7. Attach the entrance guide [B] (x2).
  8. Remove the ground plate [C] from the bottom rail, turn it over, and then attach it at the same location (x2).



  9. If the decurl unit is installed in the main machine:
    • Attach a screw at the hole marked by the red circle (marked [A]) on the guide provided with the main machine.
    • If the decurl unit is not installed in the main machine, attach the guide provided with the cover interposer tray.

  10. Attach the joint bracket [A] provided with the cover interposer tray (x4 M4x8).

    • The unit is top heavy and can tip easily once the casters are unlocked and pushed under the unit.

  11. Loosen the screws to unlock the casters, carefully move the unit to the side of the downstream unit, and then push both casters under the unit.
  12. Release the lock lever [A], push the unit against the side of the machine, push in the lock lever, and then re-attach the screw (x1).l
  13. Connect the I/F connector (x1).

  14. Remove the rear cover of the feed unit [A] (x2).

    • When you re-attach the cover, be sure that it engages correctly with the catch at [B].

  15. While holding the feed unit by the handles [A] and [B], lower the unit onto the pins below.
  16. Remove the cover [A], attach the knob screws, and then re-attach the cover (x2,x2).
  17. Attach the front spacer [A] (x1 M4x10).
  18. Attach the cover [A] to the front door [B] with “L” pins [C].
  19. Attach the front cover [A] (x2).
  20. Connect the back of the feed unit [A] (x1, x5).

  21. Attach the rear cover [B] (x2).

    • Check the harnesses and make sure that they are not pinched.

  22. Attach the step screws (x2).
  23. Set the auxiliary tray on the four shoulder screws [A], slide the tray up [B], and then fasten the tray (x2).
  24. Install the four shoes, and then adjust the height of the unit so that it is level with the main machine.
  25. Make sure that the unit is level with the main machine.
  26. To connect the base of the cover interposer tray to the downstream unit, remove the rear cover of the downstream unit, and then use the accessory screws for the base of the cover inserter tray.
  27. Be sure to tighten the screws so that there is no slippage between the units.