Up to two LCIT units can be installed in the same line.
If more than one unit is going to be installed, make sure that the software versions for the units are the same. If a unit is being added and the versions are not the same, then the software versions must be updated to the same version for both units.
No. | Description | Q’ty |
|---|---|---|
1 | Joint Bracket | 1 |
2 | Cushion | 1 |
3 | Joint Pins | 2 |
4 | Leveling Shoes | 4 |
5 | Tapping Screw : 4x10 | 2 |
6 | Screw: Polished Round/Spring: M5x10 | 2 |
7 | Power Cord | 1 |
8 | Decal- Paper Tray [3] (Not Used) | 1 |
9 | Decal- Paper Tray [4] (Not Used) | 1 |
10 | Decal- Paper Tray [T1] | 1 |
11 | Decal- Paper Tray [T2] | 1 |
12 | Decal: Paper Set Direction | 2 |
| - | Pan head screws, with washers | 2 |
| - | Connection Bracket Plates | 8 |
| - | Duct Blower Seals | 4 |
| - | Filter Covers | 2 |
- An optional tray heater can be installed under paper feed tray 2.
- Support plate [A] is packed with the paper feed tray.
The support bracket [A] is needed to correct paper skew from the LCIT.
- Use the screws provided with the plates to attach the plates to the frame of the LCIT at [A].
- Remove the plates when you need to correct paper skew, and then re-attach them when you are finished.