- If an LCT is connected to the right side of the machine, pull the LCT away from the machine and then disconnect the ground wire.
- Always disconnect the ground wire before you pull the LCT completely away from the side of the machine.
If a finisher is installed in the system, do the following procedure:
- First, turn the main machine off.
- Grip the head of the power cord, and then disconnect the main machine from its power source.
- Disconnect all the I/F cables in the system.
- Make sure the front doors of the main machine and all other peripherals are closed.
- Loosen the screw of the caster of the stack/staple unit of the finisher, raise the caster so it is not in contact with the floor, and then tighten the screw.
- Normally, the lowered caster supports the stack/staple unit of the finisher from sagging when it is pulled out of the finisher.
- However, the caster should be raised before the finisher is moved. This prevents the caster from snagging on a carpet or door jamb when the finisher is moved.
- Be sure to lower the caster again after the finisher reaches its next location.