1. Fasten the joint brackets at rear [A] and front [B] to the upstream unit (x4 M4x14).

    • To prevent interference with the Decurl Unit (if it is installed), remove and use the Decurl Unit screws to attach the upper left and right corners of the bracket (x2).

  2. Open the front door [A] of the unit.
  3. At the front right corner, remove the screw of the lock bar [B] (x1 M3x6). Keep this screw.
  4. Pull the lock bar toward you until it stops.

  5. Slowly push the unit [C] towards the left side of the upstream unit (or main machine) so that the lock bar is directly and squarely under the arms of the joint bracket [D].


    • The caster should be loose and floating free before you adjust the height of the finisher. Push the caster up and fasten it in place after adjusting the height of the finisher.

  6. Check the height of the finisher against the side of the machine.
  7. If the finisher is not at the same height as the machine, raise or lower the feet [A] with the accessory wrench.
  8. Close the front door of the finisher.
  9. Push the caster up until it stops and is not touching the floor.
  10. Tighten the caster cover screws (x2).
  11. Attach the I/F cable [E] (see the diagram for step 5) to the upstream unit.
  12. Push the finisher close to the side of the upstream unit.
  13. Make sure that the height of the finisher entrance [A] is at the same height as the upstream unit‘s paper exit [B].
  14. Push the finisher closer to the side of the upstream unit, and then once again confirm that the height of the finisher entrance still matches the height of the upstream unit exit.
  15. If the exit and entrance are not at the same height, adjust the height of the finisher.
  16. Push the finisher against the side of the upstream unit.
  17. Push the lock bar in completely so that it slides up into the notches in the arms on both ends of the joint bracket.
  18. Fasten the lock bar by re-attaching the screw removed in Step 3. (x1)
  19. Remove:
    [A] Rear upper cover (Caps x2, x5)
    [B] Rear lower cover (x4)
  20. Use a short screwdriver to loosen the bracket [A] (x3).
  21. Fasten the bracket to the upstream unit at [B] (x1).
  22. Tighten the screws (x3).
  23. Re-attach the rear covers.