• The shipping plates prevent the staple unit from moving during transport. The plates should be kept and re-attached before the unit is transported to another location.

  1. Remove all tapes and packing material from the external coves.
  2. Open the front door [A].
  3. Remove:
    [B] Tapes, retainers inside
    [C] Tag, wire, shipping plate (x2)
  4. Loosen the screws of the caster cover [A] (x2).
  5. Push the caster [B] down until it touches the floor.

  6. With the caster touching the floor, tighten the caster cover screws.

    • This relieves stress on the rails of the stacker/stapler unit when it is pulled out of the machine.

  7. Slowly, pull the stacker/stapler unit out until it stops.
  8. Remove all visible tapes and packing materials.

  9. At the right, front corner remove the tag, wire, and screw (x1).

    • If the screw is not removed, the machine will issue an SC error.

  10. At bottom front [A], remove the plate, wire, and tag (x2). Slide the plate out.
  11. At the right corner, remove the plate, wire, and tag.
    • Remove screw [A] (x1).
    • Slide the plate out.

    • Do not loosen screw [B]. This is a step screw that holds other brackets in place. Screw [B] must remain in the unit.

  12. Remove the tape from the stapler [A].
  13. Remove the plate, wire, and tab [B] (x2).
  14. On the left side of the stacker/stapler unit, remove:
    [A] Tapes, retainer at top
    [B] Tapes at bottom
  15. On the left side, remove all tape and cushions.
  16. At the rear, remove tape from the power cord.