1. Remove the right cover (x8).
  2. On the right side of the machine [A], open the clamps and free the harnesses (x3).
  3. Disconnect the operation panel arm cover:
    [A] Top (cap x1, x1)
    [B] Left side (x1)
  4. Remove the cover [A].
  5. Remove the arm lock screws [B] (x4). Do not discard these screws.
  6. At the back of the arm [A], slowly pull the harnesses out of the machine while you use your other hand to push the operation panel extension forward.
  7. When you see the four holes where you just removed the screws [B] line up with four holes in the arm below, stop.
  8. Re-attach the four screws at the new position (x4).
  9. Place the cover [A] over the arm, and then fasten it on the side (x1).
  10. Fasten the cover on top [A] and then re-attach the plate [B].
  11. At the end of the arm [A], arrange the ground wire, USB connector, and harnesses as shown.
  12. Hang the operation panel [A] by the upper holes onto the hooks on the arm mounting plate (x2).
  13. Make sure the back of the operation panel is hooked on both sides.
  14. From behind, use flat-head screws [B] to connect the front left side of the operation panel to the mounting bracket (x2).
  15. Use a flathead screw to fasten the lower right corner of the operation panel to the mounting bracket [A] (x1).
  16. Fasten the ground wire [B] loosely with the last flathead screw (x1).
  17. Position the ground wire so that it is at a 45 degree angle to the screw, and then tighten the screw.
  18. Connect both harnesses to the back of the operation panel [A] (x2).
  19. Fasten the clamp to the back of the operation panel [A].
  20. Connect the USB cables [B] (x1).
  21. Position the USB cable connection [A] as shown, and then close the clamp [B] (x1).
  22. Attach the shield plate [A] (x1).
  23. Fold the USB harness, and the other two harnesses [B] behind the shield plate.
  24. Check behind the operation panel to make sure that the harnesses are neatly tucked behind the shield plate.
  25. Set the curved bracket [A] on the top, and then fasten it [B] (x2).
  26. Use a stubby driver to fasten the flat bracket on the bottom (x2).
  27. Before you re-attach the right cover, be sure to close the clamps. (x2).