Connect the interface box to the main machine (or the most downstream Ricoh peripheral) and the 3rd party peripheral.

  • Make sure that the main power switch and AC power switch of the main machine are turned OFF and that its power cord is disconnected before doing the following procedures.
  • Also make sure that the power of the 3rd party peripheral is turned OFF and that its power cord is disconnected.
  • Rating voltage of output connector for accessory: Max.DC24V.

  • RPIP interface box type S3 is only compatible with post-processing related peripherals. At this time, it cannot be used with paper feed related peripherals.

  1. Select a location for installation where the device can be fastened securely and the status LEDs can be easily viewed.
  2. Attach the velcros to the bonding surface [A] on the back of the RPIP interface box type S3 (2 pieces).
  3. Peel off the films from the Velcro strips.
  4. Press the RPIP interface box type S3 [A] to the surface at the installation location so it sticks securely in place.

    Before performing the subsequent steps, turn OFF the AC power switch and leave it for 5 minutes so the residual charge can dissipate.
  5. Connect the I/F cable [A] to the main machine or the most downstream Ricoh peripheral.
  6. Connect the parallel cable [A] to the RPIP interface box type S3 (x2).
  7. Connect a 3rd party peripheral to the main machine or the most downstream Ricoh peripheral.
  8. Connect the parallel cable to the connector on the 3rd party peripheral.