[A]

Original

[B]

Output

Cause:

Depending on the paper thickness, floppiness, edge roughness, and curl, the image may fall out of alignment.

Solution:

Adjust the image position.

If custom paper is used

In Advanced Settings for the custom paper in use, adjust the image position.

Side 1

  • To adjust the position vertically, change the value in Adj Image Position of Side1 With Feed. (SP 1-952-001 to 100: Image Pos:Main:Side1 Custom Paper 001 to 100)
  • To adjust the position horizontally, change the value in Adj Image Position of Side1 Across Feed. (SP 1-950-001 to 100: Image Pos:Sub:Side1 Custom Paper 001 to 100)
    Side 2
  • To adjust the position vertically, change the value in Adj Image Position of Side2 With Feed. (SP 1-953-001 to 100: Image Pos:Main:Side2 Custom Paper 001 to 100)
  • To adjust the position horizontally, change the value in Adj Image Position of Side2 Across Feed. (SP 1-951-001 to 100: Image Pos:Sub:Side2 Custom Paper 001 to 100)

If custom paper is not used

On the machine operation panel: Adjustment Settings for Skilled Operators > Image Position > Adjust the image position.

  • To adjust the position horizontally, change the value in Adjust Image Position With Feed Direction. (SP1-001-001 to 008: Lead Edge Reg Thick <number>)
  • To adjust the position vertically, change the value in Adjust Image Position Across Feed Direction. (SP1-003-001 to 008: Side-to-Side Reg Tray <number>)
  • If the problem persists even though you have adjusted the setting to its maximum and minimum values, consult the product specialist.