SC202-00 | D | Polygon motor ON timeout error |
After the polygon motor turned on, or within 15 sec. after the rpm’s changed, the motor did not enter READY status. Note: There are no replaceable parts in the laser unit. If any part is defective, the laser unit must be replaced. | ||
| ||
|
SC203-00 | D | Polygon Motor OFF Timeout Error |
The polygon motor lock signal (XSCRDY signal) failed to unlock (go HIGH) within 3 sec. after the polygon motor went OFF. | ||
| ||
|
SC204-00 | D | Polygon motor error |
A error was detected in the rotation of the motor. | ||
| ||
|
SC210-00 | C | Trailing edge beam error |
The calculated magnification rate between two points was not within specification. | ||
| ||
|
SC220-00 | D | Laser synchronization detection error |
A signal was not output from the LSDB after more than 100 ms (100 ms x2) after the LD fired. | ||
| ||
|
SC230-00 | D | FGATE failed to go ON |
The FGATE signal did not go ON within the 250 ms after printing started. | ||
| ||
|
SC231-00 | D | FGATE failed to go OFF |
After the FGATE signal went on, it failed to go OFF within the prescribed time. | ||
| ||
|
SC240-00 | D | LD Error |
When the LD initialized, the LD error status was asserted twice for the LD driver. | ||
| ||
|
SC270-00 | D | BCU-LDB communication error |
At start up there was a communication error between the BCU and LDB | ||
| ||
|
SC270-10 | D | BCU-LDB communication error: Other |
At startup, the machine did not detect the ASIC | ||
| ||
|
SC274-00 | D | Image transfer error |
The image transfer data generated an error. | ||
| ||
|
SC276-00 | D | APC chip communication error |
The APC chip on the LDB is not responding. | ||
| ||
|