Use this procedure to update the LCDC (LCD Control Board).

  1. Turn the copier main switch off.
  2. Put the SD card into slot 2.
  3. Turn the copier main switch on.
  4. Stop until the card utility screen is displayed.
    After approximately 10 seconds, the initial screen opens in English.
  5. Touch [Opepanel.DOM].
  6. Touch [UpDate(#)] to start the update.
    While the data downloads, the operation panel goes off.
    The LED on the [Start] key flashes red at 1/2 second intervals for approximately 6 minutes.
    When the update is completed, the [Start] key starts to flash at 1-second intervals.
  7. Turn the copier main power switch off, remove the SD card, then turn the copier on again.