1. The machine is shipped with the arm and plate pre-installed.
  2. Make sure the three harnesses and ground wire are up behind the plate as shown.
  3. Behind the frame, attach the small white clamp to the bottom left corner.
  4. Hang the operation panel by its lower holes onto the hooks [A] and [B] on the back of the panel.
  5. Make sure that the hooks are engaged on both sides.
  6. Pull the tape to detach the upper USB cable from the back of the operation panel.
  7. Position the cable down and to the right as shown.
  8. Push the lower USB cable [A] down between the end of the arm and back of the operation panel.
  9. Extend it to the right as shown [B].
  10. Connect the USB cables (x1).
  11. Fasten the bottom USB cable [A] as shown (x1).
  12. Connect the operation panel [B] (x2).

  13. Use three accessory flathead screws [A] to fasten the back of the operation panel to the arm mounting plate [B] (x3). Do not tighten these screws yet.

    • You must use the accessory short, flathead screws here. If you use longer screws, they may damage the back of the operation panel.

  14. Attach the ground wire loosely with the last flathead screw (x1).
  15. Position the ground wire [A] so that it is at a 45 degree angle to the screw, and then tighten the screw [B].
  16. Tighten all four screws.
  17. Set the holes on the edge of the curved bracket [A] onto the metal posts on both sides, and then fit the bracket against the back of the operation panel.
  18. Check around the edge of the bracket to be sure there are no harnesses pinched between the bracket and the back of the operation panel.
  19. Fasten the curved bracket [A] (x2).

  20. Fasten the flat bracket [B] (x2).

    • Use the same screws here. These are the longer accessory hex screws, not the flathead screws.