1. Remove the two belt jigs stored inside the ITB cover you removed earlier. You need these jigs to hold the belt in the correct position for re-installation.
  2. Set the short jig on the end of the drive roller on the motor side.
  3. Set the long jig on the front shaft of the roller on the push-switch side.

    • Either edge of the belt can be lowered over the ITB unit.

  4. When you set the belt, the front edge of the belt will go down as far as the jigs on the left [A] and on the right [B]. This holds the belt at the correct position.
  5. Re-attach the belt tension plate.
  6. Be sure to remove both jigs.
  7. Return the jigs to the inside of the ITB cover.