1. If the main machine is on, turn it off.
  2. Confirm that the breaker switch [A] is set to the right.

    • The breaker switch is at the bottom of the left rear corner near the power cord. When it is set to the right, you should see a straight line (-).

  3. Connect the power cord to the finisher, then connect the other end to a power supply outlet.
  4. Use the sharp point of a pen [B] or similar tool to push in the breaker switch until it snaps to the off position. (You should see "0".)
  5. If the breaker does not snap to the off position:
    • Check that the power cord is correctly connected to the finisher and power supply.
    • Push the breaker switch again to see if it snaps to the off position.
    • If the breaker switch does not snap to the off position, it must be replaced.
  6. Be sure to reset the breaker switch to the on (-) position.