The remaining procedures are the same for both the copier model and the printer model.

  1. Disconnect the attention light base [A] (x3).
  2. Disconnect the bottom of the attention light [B] and remove the light (x2, x1).
  3. On the right side, remove the LCIT heater connector cover plate [A] (x1).
  4. Disconnect the right cover [B] (x7).
  5. Lift the cover base [A] and pull the right cover away from the machine.
  6. Disconnect the top of the operation panel arm cover [A] (cap x1, x1).
  7. Disconnect the side of the operation panel arm cover [A] and then remove it (x1).

  8. Disconnect the metal base [A] of the operation panel (x3).

    Do not loosen the shoulder screws [B].

  9. Open the harness clamps [A], and then free the harnesses [B] (x3).
  10. Disconnect the harnesses (x3).
  11. Open the ferrite core, and then remove it.
  12. Push the end of the operation panel arm [A] toward the front of the machine.
  13. Remove the base of the arm from the anchor screws [B], and then lay the base down next to the anchor screws.
  14. Slowly pull the harnesses through the hole.
  15. Pick the operation panel up, and then lay it down on a flat clean surface.
  16. Open the toner bank door.
  17. Pull off the clip and remove the toner bank door [A] (x1).
  18. Remove the toner bank front cover [A] (x3).
  19. Disconnect the front left corner of the canopy [A] (x1).
  20. Disconnect the top front of the canopy [B] (cap x1, x1).
  21. Disconnect the right side of the canopy (x2).

  22. At the rear [A], remove the filter bracket and filter from the back of the canopy (x1).

    Note the position of the notch on the edge of the filter. It must be re-installed in the same way.

  23. At the rear, disconnect the top of the canopy [A] (x1).
  24. Disconnect the left rear corner of the canopy [B] (x2).
  25. Remove the canopy [A].

Re-installation: Setting the Canopy

The procedures below are for the printer model only.

You need to be careful when you re-install the canopy cover to avoid damaging the cushions at the front and rear of the stay [A].

  1. Slowly, set the canopy on top of the toner bank.
  2. At the front and rear, set a scale on the stay and confirm that there is no gap between the edge of the canopy [A] and the top of the stay below.

  3. If you see a gap as shown at [B], this means that the left edge of the canopy is riding up on one or both cushions.

    • Be sure to check at both the front and the rear of the canopy cover for any gap.

  4. If you see a gap, carefully remove the canopy and set it again, and then use the scale again to confirm that there is no gap.

Ferrite Core

  1. Before you re-attach the right cover, re-attach the ferrite core [A].

  2. Connect the harnesses and close the clamps [B] (x3, x3).

    To prevent noise interference, make sure that the ferrite core is re-attached correctly and securely locked.