1. On the left side, pull out the interface cable.
  2. Align the edge of the plate on the tray with the slot on the side of the finisher, and then rotate the finisher up against the side of the machine.
  3. Make sure that the tabs at the rear [A] and front [B] are inserted in the slots.
  4. Connect the interface cable (x1, x1).
  5. Fasten the bottom of the tray at the rear [A] and front [B] (x2 M3x8).
  6. Set the tab of the front tray cover [A] into the hole in the tray frame.
  7. Fasten the cover at the bottom [B] (x1 M3x8).
  8. Set the tab of the rear tray cover [A] into the hole in the tray frame.
  9. Fasten the cover at the bottom [B] (x1 M3x8).

    This completes installation of the booklet tray.