1. Attach:
    [A] Left joint bracket, marked "L" (x2, M4x10)
    [B] Right joint bracket, marked "R" (x2, M4x10)
  2. Peel the tape from the back of the sponges and attach sponges and .
  3. Attach the sponge at the rear so that it is aligned at [A] and [B].
  4. Attach the sponge at the front so that it is aligned at [C] and [D].
  5. At the rear, remove screw from plate [A].
  6. Loosen screw and lower the plate so that you can see the lock bar [B].
  7. Remove the lock bar screw (x1 M3x6). Keep this screw.
  8. Push the lock bar [B] until it is unlocked.
  9. Slowly push the unit [C] against the left side of the finisher so that the lock bar is directly and squarely under the arms of the joint brackets.
  10. At the rear, pull the lock bar [B] toward you so that it slides up into the notches in the arms of the joint brackets.
  11. Fasten the lock bar by re-attaching the screw removed in Step 7. (x1).
  12. Connect the unit I/F cable [D] to the finisher.
  13. Connect the plug of the power cord to the power source.
  1. Set a leveling shoe [A] under each corner of the unit.
  2. At each corner, turn the nut to lower the bolt onto each shoe.
  3. Use a level to check each side of the unit.
  4. Turn each nut to adjust the height of each corner until each side is level.