1. Do SP2109-003 Pattern #14, and then print a Trimming Area pattern on both sides of an A3 sheet of paper.
  2. Pull out the drawer.
  3. Remove the right front cover of the drawer.
  4. Note and record the current setting at .
  5. Loosen screw and then move bracket to either the left or the right.
  6. If the trimming area pattern [A] is skewed to the rear, move bracket [B] to the left.
  7. If the trimming are pattern [A] is skewed to the front, move bracket [B] to the right.
  8. Do more trimming area pattern prints and adjustments until the sides of the trimming area pattern are perfectly parallel with the edges of the paper.
  9. If the problem persists, consult local staff and the product specialist.
The skew detection level is too low.

Increase the skew detection level.

  1. On the machine operation panel: Adjustment Settings for Skilled Operators > Paper Feed/Output > Skew Detection Level > Reduce the value. (SP1-022-001 to 008: Skew Correction Level Setting Tray<number>)
  2. Reduce the value to increase the detection level.
  3. This will allow the machine to report a paper misfeed and stop printing even for a slight skew.