1. Open the front door.
  2. Disconnect the front side of the left tray [B] (x2).
  3. At the rear [A], disconnect the left tray [B] and remove it (x2).
  4. Remove the 1st flat plate (x2).
  5. Remove the 2nd flat plate (x2).
  6. Remove the 3rd flat plate (x2).
  7. Next, set the flat plate with the cutout where you just removed the 3rd flat plate.
  8. Fasten the plate [A] (x2).
  9. Set the bracket [B] and fasten it (x1).
  10. Install the joint pins, one at the front and one at the rear.

  11. Turn the pins clockwise until they are snug against the frame.

    • The Multi Bypass Unit weighs about 20 kg. (44 lb.).

  12. Lift the bypass tray [A] and set it on top of the joint pins.
    • Use the arrow on the cover and the line on the side of the unit [B] to align the tray as you lower it.
    • The pins will slide easily into holes in the bottom of the tray when these marks are aligned.
  13. Fasten the screw [A].
  14. Check the rear [A] and the front [B].
  15. Make sure the tray is flat on top of the LCIT, and that the joint pins are visible.
  16. Fasten the tray at the front [A] and the rear [B] (x2).
  17. At the rear, open the clamp to free the three harness cables.
  18. Locate the three connection points inside the tray, and then connect the harnesses (x3).
  19. Next, install the left cover (x2).
  20. Attach the rear cover (x2).
  21. If the tray is closed, open it.
  22. Set the left cover. (This was the first cover that you removed at the beginning of the procedure.)
  23. Fasten the left cover at the rear [A] and at the front [B] (x4).
  24. This completes installation of the Multi Bypass Tray.
  25. Dock the LCIT to the side of the main machine.