Do this procedure to move the internal units to their home positions before moving the machine.

  • This procedure must be done before reattaching any braces to the perfect binder.

  1. Switch the host machine off.
  2. Open the right and left front doors.
  3. Close the right door.
  4. Insert a piece of cardboard or folded piece of paper into the slot [1] in the left door switch.
  5. Remove the service board cover [1] ( x1).
  6. On the SW1 bank, set DIP switch 1 to ON.
  7. On the SW2 bank, set DIP switches 1, 2, 4, 7 to ON.

  8. Turn the host machine on.

    • Wait about 30 sec.
    • Make sure that your hands and tools are well clear of the parts inside the machine.

  9. Slowly push [PSW1] 11 times.
    • Each push on the [PSW1] moves a unit to its shipping position (see the table below).
    • After each push, LED2 flashes until the task has been completed. Wait for LED2 to go off before you press [PSW1] again.

    No.

    Operation

    Target Unit

    1

    • Moves the blade cradle to its initial position.
    • Moves the signature press blade to its END position.
    • Moves inside the trimming unit.
    • Opens the rotation guide plate.
    • Lowers the slide to mechanical stopper.

    Trimming Unit

    (This requires more time. Wait for LED2 to turn OFF before pressing [PSW1] again.

    2

    Closes the rotation guide plate.

    Cutter Rotation Unit

    3

    Moves the trimmings buffer into the machine.

    Trimmings Unit Cutter

    4

    Lowers the sub gripper, signature gripper.

    Sub Grip Unit

    5

    Lowers the stacking tray.

    Stacking Tray

    6

    Retracts the right and left cover path guide plates.

    Cover Unit

    7

    Opens the spine fold plate (movable side only)

    Cover Unit

    8

    Closes the right and left cover path guide plates.

    Cover Unit

    9

    Rotates the main gripper.

    Main Grip Unit

    10

    Lowers the main gripper.

    Main Grip Unit

    11

    Closes the main gripper.

    Main Grip Unit

    • All three LEDs on the Service Board light after all units have been moved to their shipping positions.
  10. Set all the SW1 and SW2 DIP switches to the down positions.
  11. Switch off the host machine.
  12. After moving the machine to its new location:
    • Remove any shipping brackets that have been reattached.
    • Connect and turn on the book binder. The internal units will automatically move to their start positions.