The entire image is fainter than normal.

Cause:

This may occur when:

  • Continuously printing an image that consumes little toner
  • The machine has not been used for a long time
  • The machine is located somewhere very humid and has not been used for a while

Solution:

  1. On the machine operation panel: Adjustment Settings for Skilled Operators > Image Quality > Adjust Image Density > Image Density Adjustment: Manual Execute. (SP3-011-002: Manual ProCon :Ex Density Adjustment)
  2. Print the image. Is the problem resolved?

    Yes

    Finished!

    No

    Go to the next step.

  3. Increase the value by 1 in Adjust Maximum Image Density. (SP3-620-001: ProCon Target M/A Maximum M/A:K)
  4. Select Adjust Image Density and execute Image Density Adjustment: Manual Execute. (SP3-011-002: Manual ProCon :Ex Density Adjustment)
  5. Print the image. Is the problem resolved?

    Yes

    Finished!

    No

    Repeat Steps 3 to 5. If the problem persists even though you have increased the value to 5, consult the product specialist.