1. Open the front doors and pull the drawer out.
  2. Disconnect the support rails, and then remove the rail base. (Support Rails)
  3. Remove the drawer right cover (x5).
  4. Disconnect the motor [A] (x1, x1).
  5. Disconnect the motor bracket at the top [B] (x1).
  6. Disconnect the bracket:
    [A] Right (x1)
    [B] Left (x1)
  7. Remove the belt and then remove the bracket (with motor attached) (x1).
  8. Remove the lock plate [A] (x1).
  9. On the other side of the frame, remove the spring (x1).
  10. At the rear [A], disconnect the sensor (x1, x1).
  11. Remove the spring [B] (x1).
  12. Disconnect the plate:
    [A] Front (x2)
    [B] Rear (x2)
  13. At the front [A], disconnect the harness, and then pass the harness back through the hole (x1).
  14. Remove the plate [A].
  15. The bracket [B] of the registration entrance sensor is inside the plate.
  16. Disconnect the sensor bracket (x1).
  17. Remove the sensor from the bracket (x1, x4).