The following procedures are performed on the Notebook PC.

  1. Launch [ParameterSettingTool.exe].
  2. Press the [Restore] button.
  3. Select the parameter settings file that was prepared and select [Open].
    The parameters are displayed on the screen. Do not edit numerical values.
  4. Press the [Data Write] button and the "Transfer Form" opens.
  5. Select the port to use from the COM Port box.
  6. Press the [Connection] button and check that the Connection Status bar changes to "COMXX Connection."
  7. Press the [Write Start] button. The data write operation begins.

    When "Write End" is displayed in the [Communication Log], writing is complete.
  8. Press the [Disconnection] button and close the tool.
  9. Press and hold the emergency stop switch for about 3 seconds to cancel the write mode.
  10. Make sure the LEDs which lit up in the write mode turn off.
  11. Turn the main power switch off.
  12. Disconnect the RS-232C cable and attach the connector cover to the serial connector.
  13. Turn the main power switch ON. The written parameter data is updated after the machine is restarted (main power switch is turned off/on).
  14. "Data read" can be used to read the current parameters written to the RPIP interface box type S3.
  15. Restart the machine.