1. Pull out the drawer.
  2. Disconnect the support rails, and then remove the rail base. (Support Rails)
  3. Remove the drawer right cover (x5).
  4. Remove:
    [A] Cover (x2).
    [B] Plastic cover
  5. Remove springs:
    [A] Front (x1)
    [B] Rear (x1)
  6. Disconnect the roller at the front (x1).
  7. Remove the roller.
  8. Remove couplings from front [A] and rear [B] so that they do not become lost.
  9. At the front [A], remove the lock plate (x1).
  10. At the rear, remove the lock plate [A] (x1).
  11. Disconnect the harness near the handle (x1).
  12. Disconnect the cover plate (x4).
  13. Remove the cover plate.
  14. Remove the knob (x1).
  15. Disconnect the end of the roller shaft [A] and then remove the bearing [B] (x1, x1).
  16. At the rear, remove the registration timing motor. (Registration Timing Motor)
  17. Where the registration timing motor was removed, you can see the end of the roller shaft [A].
  18. Move the end of the shaft down into the larger hole [B].
  19. At the front, push the roller [A] aside. This makes it possible to access the following parts [B]:
    • DRB
    • TE shift unit motor
    • TE shift unit HP sensor