Observe the following points when installing and using this unit:
- Never attempt to disassemble the IEEE802.11a/g/n Unit.
- If you need to replace the unit, replace the entire unit.
- Give the Cautions chart to the customer.
- It is illegal to disassemble or modify this product. If illegal modifications are done to this product, we shall not assume any responsibility.
Depending where you use this product, or the access point you select, restrictions may be imposed on the use of some usable channels. If wireless LAN communications are not possible, check the environment or access point.
- You cannot use this option if you use Ethernet.
Check the markings on the antenna brackets and the ferrite cores of the antenna cables.
- ANT1. Antenna 1 transmits and receives. It must be installed on the rear middle side of the main machine. The ferrite core on the Antenna 1 cable is black.
- ANT2. Antenna 2 only receives. It is installed on the rear right corner of the machine. The ferrite core on the Antenna 2 cable is white.
The illustration shows both antennas installed on the back of the machine with Antenna 1 (black ferrite core) on the rear cover and Antenna 2 (white ferrite core) on the controller box cover.
- The PCB is installed in the controller box.
- Both antennas are held in place by easily installed and removed Velcro fasteners. (The antennas and cables will need to be removed before the covers can be removed to service the machine.)
- The seven clamps are fastened by two-sided tapes. The clamps can be easily opened to free the cables and then closed to once again clamp the cables.