• Before you remove the rear bottom plate lift wire, you must remove the front bottom plate lift wire. The removal procedure is the same for both wires.

  1. Remove the right tandem tray.
  2. Remove the right tandem tray cover (x2).
  3. At the front, remove the sensor assembly [A] (x3).
  4. Lift the front bottom plate slightly, unhook the wire stoppers [B], and then remove the stopper [C] and the actuator [D].
  5. Remove:
    [E] Wire covers (x2).
    [F] Bracket (front only) (x1, x1, x1)
    [G] Gear (front only)
    [H] Bottom plate lift wire

Re-installation (Bottom Plate Lift Wire)

  1. Set positioning pin [A] in hole [B].
  2. Set projection [C] in hole [D].
  3. Position the wire [E] correctly without crossing the wires.