1. Enter the SP mode and set SP1206 to "2" (OFF).
  2. Disconnect the peripheral unit from the upstream unit.
  3. Locate and remove the spacers from the peripheral unit where the problem occurred.

Locating and Removing Spacers

The photos below show where you can find the spacers for each unit.

Multi Folding Unit

Booklet Finisher, Finisher

  1. Open the front door (x1).
  2. Remove the spacers (x1).

Inserting Spacers

  1. Loosen the screws (x4) of the joint bracket attached to the peripheral upstream of the unit where the problem occurred.
  2. Insert a spacer and tighten the screws.
    If the trailing edge is skewing toward the rear of the machine, insert a spacer [A] under the front end of the bracket and tighten the screws.
    -or-
    If the trailing edge of the paper is skewing toward the front of the machine, insert a spacer [B] under the rear end of the bracket and tighten the screws.


  3. Do another run to check the adjustment. If skew is still present, insert another spacer.
    • Each spacer is 2 mm thick.
    • Only two spacers are provided, so the maximum adjustment is 4 mm (using two spacers).
  4. Enter the SP mode and re-set SP1206 to "1".