1. Turn the machine off and then wait at least 15 minutes for it to cool.
  2. Open both front doors, and then pull out the drawer.

  3. The exit motor [1] and the heat pipe roller motor [2] are on the rear left corner of the exit unit.

    • The heat sink on the end of the heat pipe becomes hot during machine operation and has sharp edges.
    • Allow the machine to cool for several minutes before you remove the motor.
    • Avoid touching the heat sink [1] with bare hands while you work.

  4. Free the harness at the corner (x3). You do not need to disconnect the harnesses.
  5. Remove the cover plate (x2).
  6. [1] is the exit motor, and [2] is the heat pipe roller motor.
  7. Use a short screwdriver to disconnect the top right corner [1] and bottom right corner [2] of the heat pipe motor
  8. Disconnect the bottom left corner [3].
  9. To prevent the motor from falling, hold the back of the motor with your other hand as you disconnect the top left corner [4].
  10. Pull the motor slightly away from the machine.
  11. Disconnect the motor (x1).