The remaining procedures are the same for both the copier model and the printer model.

  1. Disconnect the attention light base [A] (x3).
  2. Disconnect the bottom of the attention light [B] and remove the light (x2, x1).
  3. On the right side, remove the LCIT heater connector cover plate [A] (x1).
  4. Disconnect the right cover [B] (x7).
  5. Lift the cover base [A] and pull the right cover away from the machine.
  6. At the right rear corner [A], open the harness clamps and then free the harnesses (x3).
  7. Disconnect the harnesses [B] (x3).
  8. Open the ferrite core, and then remove it.
  9. Disconnect the top of the operation panel arm cover [A] (cap x1, x1).
  10. Disconnect the side of the operation panel arm cover [A] and then remove it (x1).

  11. Disconnect the metal base [A] of the operation panel (x3).

    • Do not loosen the shoulder screws [B].

  12. Push the end of the operation panel arm [A] toward the front of the machine.
  13. Remove the base of the arm from the anchor screws [B], and then lay the base down next to the anchor screws.
  14. Slowly pull the harnesses through the hole.
  15. Pick the operation panel up, and then lay it down on a flat clean surface.
  16. Open the toner bank door.
  17. Pull off the clip and remove the toner bank door [A] (x1).
  18. Remove the toner bank front cover [A] (x3).
  19. Disconnect the front left corner of the canopy [A] (x1).
  20. Disconnect the top front of the canopy [B] (cap x1, x1).
  21. Disconnect the right side of the canopy (x2).

  22. At the rear [A], remove the filter bracket and filter from the back of the canopy (x1).

    • Note the position of the notch on the edge of the filter. It must be re-installed in the same way.

  23. At the rear, disconnect the top of the canopy [A] (x1).
  24. Disconnect the left rear corner of the canopy [B] (x2).
  25. Remove the canopy [A].