Do the procedure below with the belt cleaning mode operation, even if you are replacing only the ITB cleaning unit and not the belt.

  • With long use the surface of the belt could deteriorate and become slightly rough, causing its coefficient of friction to increase slightly. Also, the edges of new blades could be sharp. These conditions could cause the blades to catch easily on the belt.
  • For these reasons, you must execute the belt cleaning mode (SP2310-001) to reduce the friction between the belt and replaced blades of the ITB cleaning unit.

  1. Make sure that the machine is off.
  2. Open both front doors.
  3. Open the lubricant blade and cleaning blade by rotating the two levers up.

  4. Remove the PTR. (PTR Unit Removal)

    • Leave the PTR unit out of the machine.

  5. Remove the drum cleaning unit. (Drum Cleaning Unit)
  6. Remove the front edge cover (x2).
  7. Turn the machine on and enter the SP mode.
  8. Do SP2310-1 (Force Lubricant - Belt Cleaning).
  9. Touch [EXECUTE], and then close the front doors.
  10. Wait for about 5 minutes.
  11. The machine will display a message to alert you that the process is finished.
  12. Open the front doors.
  13. Turn the main machine off.
  14. Install the PTR unit.
  15. Install the drum cleaning unit.
  16. Lower and lock the levers that were opened in Step 3.
  17. Turn the main machine on.
  18. Reset the counters for the replaced unit or parts
    • SP 7-622-021 for ITB cleaning unit
    • SP 7-622-022 for ITB cleaning blade
    • SP 7-622-023 for ITB lubricant brush roller
    • SP 7-622-024 for ITB lubricant bar
    • SP 7-622-025 for ITB lubricant blade
  19. Exit the SP mode and close the front doors.