Follow this procedure to remove the controller box so that the machine can fit more easily through a door or onto a small elevator when it has to be moved.

  1. Open the controller box. (Opening the Controller Box)
  2. Remove the controller box rear cover. (Removing the Controller Box Cover, Inner Cover)
  3. Remove the controller box inner cover. (Removing the Controller Box Cover, Inner Cover)

  4. Open the clamps (x8).

    • The connection point at [1] is empty.

  5. Disconnect the harness at the lower right corner of the controller board [A] (x1).
  6. At the upper left corner, disconnect harnesses [A] and [B] (x2).
  7. At the lower left corner, disconnect harnesses [A] and [B] (x2).
  8. At the lower left, disconnect the shielded harness (x1, x1, x1).
  9. On the back of the controller box frame, disconnect a harness (x1, x1).
  10. Near the top hinge, disconnect harnesses (x2).
  11. Near the bottom right corner, disconnect the small harness (x1, x2).
  12. At the lower right corner, disconnect the top connector [A] and the lower connector [B] (x2).
  13. Disconnect the fan [A], and then remove the PSU cover [B] (1x, x1, x4).
  14. Disconnect the top edge of the PSU (x4).
  15. Free the harnesses at the top of the PSU (x4).
  16. Disconnect the lower right corner of the PSU (x3, x4).
  17. Disconnect the IOB (x2, x2).
  18. Free the IOB harness (x5).
  19. Pull the shielded harness through the frame.
  20. At the upper right corner, pull the first harness [A] and the second harness [B] through the frame.
  21. At the same location, pull the third harness [A] and the fourth harness [B] through the frame.
  22. At the bottom of the box on the right rear corner of the machine, remove the lock bracket (x1).
  23. Grip both ends of the top of the box.
  24. Pull the box up off its hinge pegs, and then pull it away from the machine.
  25. Set the box in a location where it will not fall over while you move the machine.