Fluorescent lamps, LEDs, X-ray lights flicker after the machine is installed at the work site.

Cause

When the machine is turned on there is a large power surge momentarily to turn on the fusing lamps that maintain fusing temperature, causing a drop in voltage at some customer work sites.

 Action

Enter the SP mode, open SP1-134-001 (Inrush Control), and then change [0 (Disable: Default)] from “0” to [1: (Enable)]. (There may be occasions when you cannot solve the problem at some customer work sites.)

Enabling this mode changes the machine specifications, so before doing this adjustment consult with sales district managers and customers.

This Inrush Control mode is supported by the engine firmware below:

  • Printer model: Ver.1.05:12 or later
  • MF model: Ver.1.06:09 or later